Multiuser Transmission in Code Division Multiple Access Mobile Communications Systems
Ralf Irmer · Qucosa (Saxon State and University Library Dresden) · 2005
Code Division Multiple Access (CDMA) is the technology used in all third generation cellular communications networks, and it is a promising candidate for the definition of fourth generation standards. The wireless mobile channel is usually frequency-selective causing interference among the users in one CDMA cell. Multiuser Transmission (MUT) algorithms for the downlink can increase the number of supportable users per cell, or decrease the necessary transmit power to guarantee a certain quality-of-service. Transmitter-based algorithms exploiting the channel knowledge in the transmitter are also motivated by information theoretic results like the Writing-on-Dirty-Paper theorem. The signal-to-noise ratio (SNR) is a reasonable performance criterion for noise-dominated scenarios. Using linear filters in the transmitter and the receiver, the SNR can be maximized with the proposed Eigenprecoder. Using multiple transmit and receive antennas, the performance can be significantly improved. The Generalized Selection Combining (GSC) MIMO Eigenprecoder concept enables reduced complexity transceivers. Methods eliminating the interference completely or minimizing the mean squared error exist for both the transmitter and the receiver. The maximum likelihood sequence detector in the receiver minimizes the bit error rate (BER), but it has no direct transmitter counterpart. The proposed Minimum Bit Error Rate Multiuser Transmission (TxMinBer) minimizes the BER at the detectors by transmit signal processing. This nonlinear approach uses the knowledge of the transmit data symbols and the wireless channel to calculate a transmit signal optimizing the BER with a transmit power constraint by nonlinear optimization methods like sequential quadratic programming (SQP). The performance of linear and nonlinear MUT algorithms with linear receivers is compared at the example of the TD-SCDMA standard. The interference problem can be solved with all MUT algorithms, but the TxMinBer approach requires less transmit power to support a certain number of users. The high computational complexity of MUT algorithms is also an important issue for their practical real-time application. The exploitation of structural properties of the system matrix reduces the complexity of the linear MUT mthods significantly. Several efficient methods to invert the ystem matrix are shown and compared. Proposals to reduce the omplexity of the Minimum Bit Error Rate Multiuser Transmission mehod are made, including a method avoiding the constraint by pase-only optimization. The complexity of the nonlinear methods i still some magnitudes higher than that of the linear MUT lgorithms, but further research on this topic and the increasing processing power of integrated circuits will eventually allow to exploit their better performance.