Thermal performance of Inkjet-assisted spray cooling in a closed system
Gary Vondran, Kostas Makris, Dimosthenis Fragopoulos, C. Papadas, Niru Kumari · 2012
As the number of processors per die increase, chip thermal hotspots become increasingly more concentrated within smaller and smaller areas. Furthermore, these hotspots can change as processors are dynamically throttled or taken in and out of sleep mode based upon load and overall thermal budgets. Current cooling solutions (e.g. heatsinks, heatpipes, and even liquid cooling solutions) extract heat from the chip level but cannot independently control temperature at the hotspot level. The presented solution utilizes InkJet heads to deliver precise coolant flow rate independently to each chip location to maintain very high heat transfer rate via sustained liquid-to-vapor phase change. The result is a 10-100x improvement in thermal extraction rates over existing cooling solutions, achieving heat transfer rate as high as 4.5kW/cm2. Additionally, because each hotspot is maintained independently eliminating any large temperature gradient over the entire chip surface area, the ability to operate chips at higher operating points is now possible. This paper presents a heat sink prototype based on the inkjet-assisted spray cooling technology. The heat sink utilizes an air-cooled vapor chamber to condense and recirculate the evaporated liquid to achieve a fully closed system within the vapor chamber enclosure. The design of the prototyped solution is presented.