Spread spectrum and coding for multiple access communications
Qiang Wang, Vijay K. Bhargava · Canadian Journal of Electrical and Computer Engineering · 1992
Discusses the use of spread-spectrum modulation and error correction coding for multiple access communications such as mobile communications. The emphasis is on the connection between, and interdependence of, these two techniques. This connection is illustrated through three examples. The authors consider frequency-hopped (FH) spread-spectrum multiple access communications employingM-ary modulation and error correction coding. A mismatch between, for example,Q-ary Reed-Solomon (RS) codes andM-ary modulation, which is most likely to occur in practice, can drastically reduce network capacity. As a remedy, a matchedM-ary BCH code is shown to outperform an RS code with a comparable code rate and decoding complexity when the number of users in the system is large. Frequency hopping is a nonlinear multiple access system. For a linear multiple access system such as a cellular, direct-sequence, code division multiple access (CDMA) system, it is pointed out that the capacity is linearly inversely proportional to the signal-to-noise ratio (Eb/N0) required at the receiver to maintain a given error performance. Therefore the key to increasing the CDMA capacity is to increase the coding gain to reduce the requiredEb/N0. The authors demonstrate a connection between spread spectrum and coding by considering the analysis of the multiple access interference in an FH system.